So what do you do when you don’t want to pay $100 bucks for a bottom bracket? you ghetto-phy an old one to make due.
Start with a Sugino bb
mill some stuff, tap some holes, get some duct tape…. presto
100mm bottom bracket
Most impressive dirtbaggin there, my friend. Did you turn the bearing races after weld by chance or are you going to run it as-is?
Darned good stuff.
as-is. If I end up turning the bearing races, i should just turn the whole thing… which i might.
Name (required):
Email (required):
Website:
Comment:
Note: You can use basic XHTML in your comments. Your email address will never be published.
Subscribe to this comment feed via RSS
Notify me of follow-up comments via email.
Most impressive dirtbaggin there, my friend.
Did you turn the bearing races after weld by chance or are you going to run it as-is?
Darned good stuff.
as-is. If I end up turning the bearing races, i should just turn the whole thing… which i might.